A command for the manual/automatic simultaneous valid axis was issued from the automatic mode. The manual speed command was issued while the "tool length measurement 1" signal is ON. Remedy - The servo OFF function is valid, so release it first. - An axis that can be removed has been issued, so perform the correct operations. This manual is referred to when using the MITSUBISHI CNC /70 Series. This manual explains how to operate, run and set up this NC unit. Read this manual thoroughly before using the NC unit. To safely use this NC unit, thoroughly study the "Precautions for Safety" on the next page before use. Introduction 8 TPS User Manual en A laser distancer (EDM) is incorporated into the instruments of the TPS series. In all versions, the distance can be determined by using an invisible infrared beam which emerges coaxially from .
faa approved installation manual for the egt # applicable to egt and edm the owner of this egt must keep this manual 1) installation overview 3 2) initial bench check 3 3) installing the instrument 3 4) exhaust gas temperature (egt) probe 4. faa approved installation manual for the egt # installing the egt scanner® rev-c the owner of this edm/ must keep this manual table of contents page 1) installing the indicator 2 2) exhaust gas temperature probe 2 3) turbine inlet temperature probe 2. EDM These are the important differences between the EDM and EDM Upon power up the EDM will scan in the Automatic primary mode only the highest CHT, TIT, and OIL. It will scan all parameters in the Manual mode and Automatic non-primary scan modes. To automatically scan all parameters, tap STEP and then tap LF.
Read carefully through the User Manual before you switch on the product. Product identifica- reflector with Electronic Distance Measurement (EDM) mode. FAA APPROVED INSTALLATION MANUAL FOR THE EGT # The EDM input is also compatible with the aircraft's factory TIT and may be piggy backed. EDM Quick Reference. 1. Start Engine Manual Scan – Tap STEP if manual scan is desired. 7. Return to Auto Scan – Tap LF, then tap STEP (Fig. 1).
0コメント